19ft Stirling Monza Ski/Wake boat in GOSNELLS, Western Australia for sale
I bought this ski boat 2 years ago, In the past 6 months I have completed a groud up rebuild as I had every intention to keep it for the following summers. Due to work requirements id like to sell it and move up North.
New Aluminium Trailer, Localy made
Remanufactured and Marinized 350 Chev - 13 hours old, undwer warranty until September.
New Electrical. Including switches and some guages
New Fuel System, including water seperator and filter
Wicked Wake Tower
Stereo
Vinyl Interior
Fire extinguisher
Bilge Pump
New dog clutch shifter and tube knuckles
New battery with box, new isolater, fuse box and 12 volt power supply
New Prop shaft, Log gland, and shaft bushing..
The trailer was built by a Aluminium fabricater/boat builder late last year. It has a professionally rolled draw bar/Chassis, New rubbing strakes, Stainless Winch, Jockey Wheel, Axle, Wheel bearings, Hubs. Tyres are in good condition along with the Rims, Springs and wheel arches were reused. Licenced for 9 more months.
Remanufactured 010, 350 Chev block, 30 Thou over, 4 bolt mains, brass whelsh plugs, Stage 4 Dynotec cam - (Idle too 5000 rpm power range), Rollmaster double row timing chain, New hypertec pistons and King bearings, Around 10.5 - 1 Compression. Reground Crank, recon Cast heads that were re-faced, crack tested, new LtI springs, re seated and replacement of the Valves where needed. Hydraulic lifters and push rods, Marine head gaskets and exhaust, New Marine 650 Holley, mechanical secondaries with internal needle and seat along with return overflow for insurance purposes, New hi torque starter motor, New fuel pump, MSD HEI Distributer. 330hp but I cant confirm that on paper. All new parts used and built by a mechanic - Has warranty for 3 more months.
PLEASE READ - The bow side gunnel rubber on the Port side has been hit from a person reversing the trailer which jackknifed. The previous trailer had a bow restaint which inturn hit the hull and dented the gunnel strip. Its not bad and can be reapired quite easily, No fibreglass was damage just the rubbing strake was dented up, I havnt fixed it because I would need to buy X amount of lengths of it for shipping from the east coast and have been too busy with the other works. I would consider fixing it for the right price.
Thanks
Cint
